Beverage Centers Diagnostics

Monogram Beverage Centers
Error Codes

Meanings, severity levels, safe checks you can perform, and when to call a technician.

Enter the code shown on your beverage centers display

Is it safe to keep using it?

Depends on code severity. Low/Medium codes often allow continued use, High severity requires immediate stop.

Can error codes be reset?

Some codes clear after power cycle. Persistent codes indicate underlying issues needing repair.

When should I stop using it?

Stop immediately for water leak codes, burning smell, or any High severity error.

Most Common Codes

TC DE CC HI PF

All Codes

CC DE HI PF TC

Error Code Directory

Click any code for detailed troubleshooting steps

Low Medium High

Code Meaning Severity Common Symptom

CC Compressor control fault High Stored cans, bottles, and beverages gradually warm to room temperature as the compressor is unable to run and provide cooling. View DE Door open too long Low The glass or solid door of the Monogram beverage center is not fully closed, allowing warm kitchen air to enter and warm stored beverages. View HI Compartment not cooling properly Medium The most directly observable sign is the HI fault code on the Monogram ZDB beverage center's digital display, typically accompanied by an audible alert tone. The displayed actual temperature will read noticeably higher than the programmed set point. View PF Power failure notification Low The primary and most observable sign is the PF code appearing on the Monogram ZDB display immediately when power is restored following an outage. The code is a historical notification rather than an active fault, alerting the user that the unit's power was interrupted. View TC Temperature sensor fault Medium Beverages stored in the Monogram beverage center are warmer or cooler than expected, as the control board cannot accurately regulate compressor cycles without a valid thermistor signal. View